How to Reuse Magnetic Lashes: A Simple Care Routine
By Luxury Lashes by Lilly Ghalichi | Published: 2026-10-16
Category: Tips og stell
Magnetic lashes can be worn many times if you keep the magnets and band clean. Follow this simple routine to remove, wash, dry, and store them so they stick like new.
Quick answer
To reuse magnetic lashes, peel them off gently, clean the band and magnets with a cotton swab dipped in oil-free makeup remover, let them air-dry fully, and store them in their tray. Do this after every wear, and you can get many uses before the magnets weaken or the band loses shape.
What wears out on magnetic lashes first
Magnetic lashes rarely fail all at once. The first thing to go is usually the grip. Lash glue, oil, and liner residue build up on the magnets and band, creating a barrier that stops the magnets from meeting your magnetic liner cleanly. The second weak point is the band itself. Bending, pinching, or storing them loose can warp the curve so the lash no longer follows your lash line.
That is why reuse is mostly a cleaning and storage habit, not a repair skill. If you keep the magnets bare and the band curved, the lash will keep working. If you skip cleaning, even a well-made pair will start sliding or lifting within a few wears.
How often to clean magnetic lashes
Clean them after every single wear if you use magnetic liner. Liner residue is the main reason magnetic lashes stop sticking. If you wear them without liner, or only spot-clean the band, a full wash every two to three wears is usually enough. Never wait until the magnets feel slick or the lash starts to lift before you clean them.
A good checkpoint: run a clean finger along the magnets. If you feel any tackiness or see a dark film, clean before the next wear.
Magnetic lash care when you are short on time
If you cannot do a full wash, do a magnet-only wipe. Hold the lash by the outer corner, swipe each magnet with a dry cotton swab, then follow with a swab lightly dampened with oil-free remover. Let it dry for a minute before storing. This quick step removes the liner film that causes most sticking problems.
Do not use this shortcut more than two or three times in a row. Eventually residue works its way into the band fibers, and only a full wash will remove it.
Your step-by-step magnetic lash reuse routine
- Peel from the outer corner: Start at the outer corner and peel the lash inward with your fingers or a slanted tweezer. Support the band with your other hand so it does not bend. Mistake to avoid: yanking from the middle. That warps the band and can pull magnets loose.
- Wipe the magnets first: Use a dry cotton swab to remove loose liner and glue from each magnet. Work along the band one magnet at a time. Checkpoint: the magnets should feel smooth, not tacky, before you move on.
- Wash the band with oil-free remover: Dampen a clean cotton swab with oil-free makeup remover and gently run it along the band and magnets. Do not soak the lash or submerge it in water. Mistake to avoid: oil-based removers. Oil leaves a film that stops magnets from gripping.
- Rinse with a clean damp swab: Go over the band once more with a swab dipped in plain water and wrung out. This lifts any remover residue left behind. Checkpoint: no visible film or stickiness on the band.
- Air-dry completely: Lay the lash flat on a paper towel, band up, and let it dry for at least 20 minutes. Do not use a hairdryer or towel-dry it. Mistake to avoid: storing while damp. Moisture traps residue and can rust or dull the magnets.
- Store in the original tray: Place the lash back in its tray, curve facing the same way it came. Keep the tray closed and away from heat and direct sun. Next step: rotate pairs so each lash gets a full rest between wears.
Product notes for magnetic lash wearers
- Magnetic Mykonos: Magnetic Mykonos is a dramatic round 3D faux mink lash with a magnetic hold, designed for larger eye shapes that want bold volume and length. The Magnetic Collection is being discontinued, and magnetic liner is not included and is no longer available on the site. If you already own Magnetic Mykonos, caring for the magnets matters more than ever because replacement liners are no longer sold here. Keep the magnets spotless so the lashes you have stay wearable as long as possible.
- WispyFlares: WispyFlares are pre-glued self-adhesive toppers with a spiked V-shaped design. They can layer over natural lashes or stack on top of another lash for extra drama. If you are rotating away from magnetic styles, these are a practical alternative for layering, and they follow the same basic rule: clean the band after each wear to keep the adhesive working.
- Envy: Envy is a synthetic flare lash with light semi-natural wispy layers, mild volume, and soft medium length at 15mm. A lighter lash like Envy puts less weight on the band, which can help a magnetic or adhesive lash hold its shape longer between cleanings.
